この問題の解決方法がこちら!
まずヘッドの部分についている小さなネジ①をはずします。ヘッド固定用のつまみ②をはずします。そうするとヘッドが取れます。なんらかのゴム③を本体側のお皿の部分④に乗せ元に戻します。ゴムはインナーイヤホン用の余ったイヤーピースなんかがオススメです。これで全くぶれなくなります。超簡単で効果絶大ですので是非お試し下さいませ!
Yesterday we introduced you a new and cool way to mount your GO-DJ. Actually we did want to clarify one little drawback that we noticed. The product originally called UCS-10 was intended to secure the camera but we have noticed that a little force on the head portion does give you stable hold. Luckily we have a little tweaking solution to solve that. See below on instructions to correct this!
1. First remove the small screw pictured as ①. 2. Remove the knob pictured as ② that secures the head. 3. Then I will take a small piece of rubber as shown as ③ and place it in the area pictured as ④.
Note: We highly recommend using Rubber for placement as it will drastically reduce any shaking or loose ends for the stand. You may often find extra pieces of rubber from additional ear bud pieces found when you purchase in-ear headphones but any small rubber piece will do. It is super easy and highly effective to ensure you have a stable stand to go along with your Monster GO-DJ.
Remember you can always purchase your GO-DJ from www.monstergodj.com if you don't already have one.
Good luck on your setup!
Note: We highly recommend using Rubber for placement as it will drastically reduce any shaking or loose ends for the stand. You may often find extra pieces of rubber from additional ear bud pieces found when you purchase in-ear headphones but any small rubber piece will do. It is super easy and highly effective to ensure you have a stable stand to go along with your Monster GO-DJ.
Remember you can always purchase your GO-DJ from www.monstergodj.com if you don't already have one.
Good luck on your setup!
0 件のコメント:
コメントを投稿